F-Zero AX aide

Vous voulez parler de système d'arcade, de borne d'arcade, de joystick, de hardware console. Vous voulez des infos sur un point technique, c'est ici. 8292
Message
Auteur
Avatar de l’utilisateur
bobi
stick de diamant
Messages : 6076
Inscription : 03 sept. 2006, 19:55
Localisation : 57
A remercié : 14 fois
A été remercié : 43 fois

F-Zero AX aide

#1 Message par bobi »

Je viens de rencontrer un problème de palette au volant (la gauche) sur ma F-Zero AX :crybaby:
Le problème n'est pas récurrent , par la je veux dire que pendant 1 semaine la borne fonctionne à 100% et un jour le problème est présent...... et le lendemain plus de soucis
Dans l'input test je constate qu'elle se met sur ON puis bascule sur OFF et ainsi de suite , ce qui provoque en jeu un problème de direction, le vaisseau tire sur la gauche :palm:

Vidéo du problème




Est ce le micro switch qui rend l’âme ?

Dans le manuel (http://store.playitamusements.com/Manua ... %20STD.pdf) en page 95 il y a une procédure pour "ajuster" :roll: mais je n'ai rien compris

Une idée ?
Dernière modification par bobi le 30 mai 2016, 20:35, modifié 1 fois.
mes ventes : http://www.neo-arcadia.com/forum/viewtopic.php?f=9&t=22886

mes recherches : http://www.neo-arcadia.com/forum/viewtopic.php?t=21293

glstar
stick d'argent
Messages : 822
Inscription : 14 mai 2009, 14:26
Localisation : Italy
A remercié : 0
A été remercié : 2 fois

Re: F-Zero AX aide

#2 Message par glstar »

bobi a écrit :Je viens de rencontrer un problème de palette au volant (la gauche) sur ma F-Zero AX :crybaby:
Dans l'input test je constate qu'elle se met sur ON puis bascule sur OFF et ainsi de suite , ce qui provoque en jeu un problème de direction, le vaisseau tire sur la gauche :palm:

Vidéo du problème




Est ce le micro switch qui rend l’âme ?

Dans le manuel (http://store.playitamusements.com/Manua ... %20STD.pdf) en page 95 il y a une procédure pour "ajuster" :roll: mais je n'ai rien compris

Une idée ?
I had a similar problem with my deluxe unit when i got it.
Difference was that i had the big boost button to press sometimes automatically.
I had to dismount the controller unit just to discover that all was caused by the cable that goes inside the controller unit.
Similar to what you can see with f355 steering wheel, inside the steering unit of Fzero, there's a sheath containing 5-6 cables needed for all the buttons and paddles there are on the steering unit.
Probably caused but steering for ages, this sheath and one cable inside (in my case the turbo) brokes and the cable touch the gnd cover that is outside the sheath.
The effect of this problem was that is like you press the button (signal cable that touch the gnd).
Fix this was simply, just use insulation tape over that and the problems should gone.

I hope i explain this in a good manner.
Let me know if you need some help in this.

Répondre