je voudrais parler des platines universel ou une annonce sur ebay nous donne les infos pour mesurer la résistance des valeurs dans le Yoke.
http://www.ebay.com/itm/Universal-Repla ... 1c2a31489f
This chassis will work for 25"-29" Monitors. New Wei Ya Replacement chassis. This chassis is for standard resolution CRT CGA only...if your monitor was another resolution, it will now be standard. This chassis will not replace all, but it will replace most. To determine if it will work on your monitor please follow these instructions.
You must find a CRT with these specifications:
1) Measure the vertical ohms, it should be 6 ohms to 12 ohms, usually the yellow and green wires coming from the Yoke. If yours is not between 6-12 ohm this chassis will not work! (YOU WILL FRY IT IF NOT IN THIS RANGE!)
2) Measure the horizontal ohms, usually the red and blue wires. It should measure over 1.5 ohms. If not you can take a 5 to 10 watt 1 ohms resistor and add it in series to the circuit to increase the ohms to get it over 1.5.
120vac Isolation transformer is required.
Donc quand on voit les Yoke Data sur les photos ci dessous
http://www.aliexpress.com/item/SC-25-29 ... 18401.html
http://www.aliexpress.com/item/29-inch- ... 75866.html
http://www.aliexpress.com/item/25-29-We ... 13727.html
Est ce que l'on pourrait référencer ou aurait on un site, qui référence les Yoke Data de nos bornes japonaises.
Tubes toshiba, samsung, panasonic, nanao et etc....
Qu'en pensez vous ?